Setup Instructions for Gaming Station – Xbox Series S/X
Installation
- Connect HDMI, USB and Power cable at left rear of gaming station to Console.
- Place Console in to gaming station between foam blocks, as far to the left of the case as it will go, Push all the way down to the base of the case.
- Fit up to 2 controllers under strap on right side of case.
How to use
- Simply connect the extended power cable plug to a power supply and this powers both the Console and the monitor.
Safety Notice
Always store controllers and power cable behind straps to stop damage to monitor when transporting Gaming Station.
Always keep Gaming Station lid open when in use, before closing lid, switch Xbox off and give sufficient time to cool before closing case.
Gaming Station has sufficient room around the top for cooling the Console and is in accordance with manufacturers recommendations, However, during prolonged use it may be necessary to remove Console from case to allow better cooling, this is especially true with older units where the fans and vents may not be as effective as when they were new.
Although every care has been taken during the design and construction of the Gaming Station to make sure the contents remain safe and cool enough when in use, It's the responsibility of the customer/user to make sure the console does not overheat when in use and that damage isn’t caused during transportation. Any damage caused to the console or monitor will not be covered by Portable Gaming Solutions.
For more information please see our terms and conditions on our website or contact scott@portablegamingsolutions.com